Samsung RF65A977FSR Manual Del Usuario página 68

Ocultar thumbs Ver también para RF65A977FSR:

• A newly installed filter may cause the water dispenser to spurt water briefly. This is

because of air entering the waterline.

• This replacement process cause the refrigerator to drip water onto the floor. Simply

wipe up with dry cloths.

Reverse osmosis water filtration system

The water pressure of the water supply system to a reverse osmosis water filtration

system must be between 206-861 kPa (30-125 psi).

The water pressure of the reverse osmosis water filtration system to the refrigerator's

cold water line must be at least 206 kPa (30 psi). If the water pressure is below the

• Check if the sediment filter in the reverse osmosis system is blocked. Replace the filter

if necessary.

• Refill the water tank in the reverse osmosis system with water.

• If your refrigerator has a water filter, it may further reduce the water pressure when

used in conjunction with a reverse osmosis system. Remove the water filter.

For more information or servicing, contact a licensed plumbing professional.

Untitled-1 68

4. Pull out to remove the cartridge.

- If the water filter is severely

contaminated, the cartridge may not

be easy to remove. If that is the case,

use force to remove the cartridge.

- To prevent water leaks from the

filter opening, pull the cartridge

straight out while removing it.

5. Insert a new filter cartridge. Use only

Samsung-provided or approved filters.

6. Turn the cartridge knob clockwise to

lock into place.

7. Close the filter cartridge cover.

8. On the control panel, go to More

Options, and then run Filter Reset.