CAR REPAIR SYSTEM SUPPORT FOR DISASSEMBLED PARTS A+B Manual De Instrucciones página 5

EN
2004-001813 SUPPORT FOR DISASSEMBLED PARTS
ASSEMBLY INSTRUCTIONS
1. Assemble the Casters (#12) onto the Base Frame (#9) with Washers and Lock Nuts. Repeat this step for the
other casters. Place the HDF Trays (#10) on both the upper and lower levels of the Base Frame (#9).
2. Depress the Braked Casters (#11) before proceeding with the assembly. Align the square tubes of the Side
Panel (#1) with the base, maintaining a level position, and insert both ends simultaneously into the base.
Repeat this step for the other side.
3. Suspend the Upper Shelf (#4) between the two Side Panels (#1) at the desired height for use.
4. Align the square tubes of the Upper Tie Bar (#2) with the square tubes on both sides of the Side Panels (#1),
and use the Upper Tie Bar to secure the two Side Panels in place.
5. Insert 4 Outer supports (#8) on both sides of the Base Frame (#9), suspend one end of the Bungee cords
(#7) on the Outer support, and suspend the other end at any point on the Side Panels according to the desi-
red usage position.
6. Hang the remaining Document Supports (#3), Handle (#5), and Basket (#6) as desired on the mesh panel.
5