STORY MONARCH Manual Del Usuario página 14

EN
INSTRUCTION
(2) in and turn approximately 90 degrees so it is in the "IN" position.
The correct pressure for this SUP board is:
Maximum 1 bar / 15 PSI (=1000 mBar)
DO NOT EXCEED THIS!!
Using an electrical pump or air compressor is at your own risk. This can lead to damaging
the SUP board.
DETACHABLE FIN ON BACKSIDE OF SUP BOARD
It is recommended to use the detachable n in deep water, where it will allow you to
move forward in a straight line. Do not use it in shallow water because then the skeg can
hit the bottom. The n can be placed on the SUP board if this is in ated or de ated.
Assemble the n
Push the n in the black part on the To lock the n, fasten the screw into the
bottom side of the SUP board. n and screw-plug.
Then slide the n to the front of the black
box.
14.