Chicago Pneumatic FRL 1/2 BSP Instrucciones Del Producto página 9

Air Filter - Regulator - Lubricator
Installing the Mounting Plate and Control Panel Nut
1. Guide the module (2) through the hole of the mounting plate (1).
2. Install panel nut over the mounting plate (1).
3. Tighten the control panel nut to a maximum tightening torque depending on the model, as follows:
• FRL 1/2": 8 Nm (70.8 in.lbs)
• FRL 3/4": 10 Nm (88.5 in.lbs)
• FRL 1": 10 Nm (88.5 in.lbs).
EN
© Chicago Pneumatic - 6159990240
Installation
9