Assembly - Aco Lipujet P-Rb Instrucciones De Empleo

LipuJet - P -RB / - RD / - RM / - RA / - RAP
Installation

2.12.3 Assembly

Push the seal [ 9 ] over the submersible
pipe [ 6 ] as far as it will go towards the
flange [ 5 ] .
Insert the submersible pipe [ 6 ] into the
opening
it downwards into the tank.
Place washers [ 3 ] on the screws [ 1 ] .
Screw the screws [ 1 ] into the threaded
sleeves of the mounting flange in
the upper section and tighten them
crosswise with a tightening torque of 20
to 25 N . m.
88/ 454
The opening (right or left) in the upper section is already prepared according to
the article number of the grease separator that was ordered.
Heaviest single component is approx. 1.5 kg.
Numbers in brackets " [ ] ",
"Components".
on the upper section and turn
Representation of the components _ Chap. 2.12.1