Voltage Supply Cables - Acd Gruppe Mft10 Guía Breve

Connection scheme (not true to scale)
MFT rear side
The connection port is located in the cable entrance area on the back of the MFT10/MFT12.

2.2 Voltage Supply Cables

The voltage supply cables (Figure 10 and Figure 11) are provided for operating the MFT10/MFT12 on a DC
power source.
Voltage supply cable (3x 1 mm²), Length: 4 m. With 15 pol. SUB-D-connecting plug. Allows the use of the
ignition function.
Figure 10: Voltage supply cable (3 wired)
Onboard power cable for quick-change system with round plug connector (3 wires). Cable between battery
and plug connector, length: 3 m cable between plug connector and MFT10/MFT12, length: 23 cm. With 15-
pin SUB-D connector plug. Makes it possible to use the ignition function. IP65 round plug connector for easy
disconnection of the MFT10/MFT12 from the onboard power supply. The cable shaft cover with screw
connection does not need to be opened for this.
Figure 11: Onboard power cable for quick-change system with round plug connector (3 wires)
MFT10_MFT12_Accessories_Accesorios_Brief_Overview_Resumen_breve_FCC_V1.10_en_es
15pole
Sub.-D.
ACD table power supply
mains side,
voltage
depends on
the country .
mains plug
6 / 28