Edit Gas Charge Data; Instructions Manual; Edit Gas Charge Mode; Start Procedure - Sun Eck Flag Manual De Instrucciones

Use the keys 0 to 9 to type the volume of UV to be injected, can never be more than 10 ml.
* UV is disabled while servicing HYBRID VEHICLE

EDIT GAS CHARGE DATA

NOTE: For most systems the quantity of fluid to be refilled is indicated on a plate that is in the
vehicle's engine compartment. If this quantity is not known, look for it in the relevant manuals.
Use the keys 0 to 9 to type the quantity (in grams) of refrigerant to be charged into the A/C
system.
NOTE: If DATABASE is installed, can be used to insert the value of refrigerant into the GAS
FILLING field.

EDIT GAS CHARGE MODE

Select the connection mode:
- HP+LP fill the refrigerant from both HP and LP service ports
- HP to fill the refrigerant only from the HP service port,
- LP to fill the refrigerant only from the LP service port,

START PROCEDURE

After selected all the procedure data, press
displayed:
Connect and open the coupling (HP, LP, or HP/LP, depend of the previous choice) connected

INSTRUCTIONS MANUAL

MANUAL / OIL-UV INJECTION
PAG1/POE H
UV H
REFRIGERANT FILLING
1 2 3 4 7
5 6
MANUAL / OIL INJECTION
PAG1 POE H UV H
10 ml 0 ml
MANUAL / OIL INJECTION
Connect and open HP and LP couplings
To A/C system and press to continue
-44-
DD/MM/YY XX:XX PM
0
ml
0
ml
0
g
8 0 . <
9
DD/MM/YY XX:XX PM
Gas filling
100 g
5 ml
to continue, the following screen will be
DD/MM/YY XX:XX PM