Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
1. Make sure unit is on acceptable work surface and connect to power,
unit will produce an audible beep when it is connected to power.
2. Display will show program mode, speed in rpm, and time.
3. For continuous mode press Play and the unit will turn on.
4. Turn unit on with power button, hold power button for a moment to
turn on (audible beep).
5. Once mode is chosen, RPM display will flash. To set speed use
Touch & Slide to desired number.
6. If time control is desired press time control button. Number value will
flash when ready to set, use Touch & Slide to enter number. Timer has
two setting modes: in seconds "s" or in minutes "m". "s" displayed
/ Minutes & Seconds setting: max is 59 minutes : 59 seconds "m"
displayed / Hours & Minutes setting: max is 50 hours : 00 minutes
7. For intermittent mode a tube must be pressed into the vortex pocket
to activate the unit, unit will run until time runs out or tube is removed
from vortex pocket.
v5.24
8. Turn unit off same way it is turned on.
12
Publicidad
