Connecting Up A Device With Digital I/O Communication - TDK relyon plasma piezo brush PZ3-i Manual De Instrucciones

5.6

Connecting up a device with digital I/O communication

Connect up the line connecting module and driver housing. Then hand-tighten all cap
nuts.
Connect the communication connecting line to the driver housing.
Connect the DC connecting line to the driver housing.
Connect equipotential bonding to the earth potential.
Sample illustration of a single device with digital I/O communication. The setting required
for this at the Config port is already set when the device is supplied and does not need to
be adjusted for this operating mode. The removable module carrier, module connecting
line and gas line are not shown here for the sake of clarity.
20 BA-PZ3_i_ML / F0354902