Workflow - Autool Pt520 Manual Del Usuario

Workflow

Automatic Shutdown
● The device will automatically power off after 10 minutes of
inactivity or when there's no pressure applied.
●
Long press the power button [
instrument and enter the main screen.
● Connect PVC hoses to both ends of the pressure sensor.
●
Press the data record button [
● Long press the zero button [
atmospheric pressure calibration. (Page displays calibration
status
P=0
●
Press the record button [
record button [
record up to 29 sets of data.
● After recording the data, long-press the record button [
The interface will display a viewing icon [
you are in viewing mode. (Max: This represents the maximum
reading since the instrument was last turned on or reset; Min:
This represents the minimum reading since the last measure-
ment taken by the instrument.)
●
In viewing mode, press the select button [
view recorded data.
●
Long press the record button [
the main screen.
)
] to start recording data; Press the
] again to add another set of data. Repeat to
5
] for 3 seconds to turn on the
] to enter the record mode.
] for 5 seconds to perform
], indicating that
] to toggle and
] for 2 seconds to return to
].