Chamberlain 050ACTBMC Instrucciones De Instalación

Installation
1
Before you begin
Your garage door opener has an internal gateway located on the receiver logic board. After installing the new receiver logic board, use the myQ
garage door opener to your myQ account. The products illustrated in the instructions are for reference. Your product may look different.
To prevent possible SERIOUS INJURY or
DEATH:
• Disconnect ALL electric and battery
power BEFORE performing ANY service
or maintenance.
To prevent damage to the receiver/logic
board, DO NOT touch printed circuit board
of replacement receiver/logic board during
installation.
ALWAYS wear protective gloves and eye
protection when changing the battery or
working around the battery compartment.
2
Remove the receiver logic board
2.1 Disconnect the wires from the quick-connect terminals (A).
Remove the receiver logic board end panel from the garage
door opener.
A
To insert or remove
the wires from the
terminal, push in the
tab with a
screwdriver tip.
1.1 Remove the light lens by pulling the
top sides of the light lens and rotate the
light lens down. Squeeze the light lens
clips to remove lens from end panel.
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth
defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
2.2 Unplug the wire harnesses from the receiver logic
board. You may need needle-nosed pliers to remove
the harnesses.
RECEIVER LOGIC BOARD REPLACEMENT
1.2 To maintain your warranty, place the
provided label over the existing label
on the end panel of the garage door
opener.
TO ERASE ALL ELIMINACIÓN DE
RECEIVER CODES TODOS LOS CÓDIGOS DEL
1. Press and HOLD RECEPTOR
receiver orange
1. MANTENGA PRESIONADO
ERASE button el botón naranja "ERASE"
6 seconds. Indicator del receptor durante 6
light will turn ON. segundos. La luz del
indicador se encenderá.
2. Release button
when light turns OFF. 2. Suelte el botón cuando la
luz se apague.
PART NO.: NO. DE PIEZA:
CANADA: DATE:
DANGER • PELIGRO
THE CHAMBERLAIN
GROUP, INC., USA
Ensamblado en México
TO ERASE ALL RECEIVER CODES ELIMINACIÓN DE TODOS LOS CÓDIGOS DEL
1. Press and HOLD RECEPTOR Assembled in Mexico
ERASE button receiver orange 1. MANTENGA PRESIONADO
6 seconds. Indicator del receptor durante 6 el botón naranja "ERASE"
light will turn ON. indicador se encenderá. segundos. La luz del
when light turns OFF. 2. Release button 2. Suelte el botón cuando la 132C2280-3D
luz se apague.
PART NO.: NO. DE PIEZA:
CANADA: DATE:
DANGER • PELIGRO
THE CHAMBERLAIN
Ensamblado en México GROUP, INC., USA
Assembled in Mexico
132C2280-3D
2.3 Remove the receiver
logic board from the
end panel by removing
the 2 screws and
releasing the 2 clips.
1
Models 050ACTBMC and 050ACTBLKMC
Replaces 050ACTWF and 050ACTWFLK
serial number found on the provided label to add your
®
1.3 Disconnect power to the garage door
opener.
Wire clip
Clips
Screws