Assembly; Tube Assembly; Using The Product; To Turn The Tool On - Greencut Eb56Li-Ion Manual De Instrucciones

ASSEMBLY

TUBE ASSEMBLY

To attach the front tube to the rear blower tube, align tubes
so that the open slot in the front tube is in line with the tube
latch on the rear tube. Press firmly together until the slot
locks in place over the tube latch. Make sure connection is
secure. (Fig. 1).

USING THE PRODUCT

TO TURN THE TOOL ON

Slide on/off switch forward to "ON" position. To turn the tool OFF, slide backward to "OFF" position.
WARNING
Do Not use the blower with any type of accessory or attachment. Such usage might be hazardous.

AIR SPEED CONTROLS

Rotate the speed control Wheel to accelerate or decelerate air speed. By pressing turbo button, air speed will
immediately accelerate to maximum level. (See fig. 2).

BLOWING

Blower can be used to clean corners, fences, walls, wooden areas or beneath cars. Be careful how you point the jet of
air as it could move heavy material and cause injury or damage. Turn the switch to on, point the jet of air in front of
you and move forward slowly to gather together the leaves or to move the leaves from inaccessible areas.
WARNING
After battery has been fully depleted, make sure switch is in the "OFF" position.
Avoid collisions with hard objects which could damage
your blower.
Keep bystanders and animals at least 15 feet (5 m) away
from the working area.
Make sure that the switch is in "OFF" position, the
battery pack is disconnected and all the rotating
parts are at a standstill before cleaning, carrying out
inspections or moving from one place to another.
Do not put part of your body such as hands and fingers
in the exhaust opening.
Do not switch the machine on in enclosed or poorly
ventilated spaces or in the presence of flammable and/or
explosive substances such as liquids, gas and powders.
Open slot
Botón de turbo
45
EN