Servicing The Fuses; Drive System Maintenance; Checking The Tire Pressure - Toro TimeCutter Max Manual Del Operador

Servicing the Fuses

The electrical system is protected by fuses. It requires no maintenance; however, if a fuse
blows, check the component/circuit for a malfunction or short.
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Replace the blown fuse with a new fuse.

Drive System Maintenance

Checking the Tire Pressure

Maintain the air pressure in the front and rear tires as specified. Uneven tire pressure can
cause an uneven cut. Check the pressure at the valve stem when the tires are cold to get
the most accurate pressure reading.
1. Inflate the front caster wheel tires to 206 kPa
(30 psi) or the pressure indicated on the
sidewall, whichever is lower.
2. Inflate the rear drive-wheel tires to 90 kPa (13
psi).
3465-589A
ARK
G440132
Page 5–20
position.
Charge circuit (15 A)
Main (25 A)
G441539
Maintenance: Electrical System Maintenance