Control Panel; On/Off Button; Mode Button; Light Button - Dreiha Atmos 2.6 Manual

CONTROL PANEL

Note: If the remote controller is missing, operate on the control panel

1. ON/OFF button

Operation starts when pressing this button, and
stops when pressing this button again.

2. LIGHT button

Press this button to turn on or turn off display
light on indoor unit.
3. (+/-) button
Press the + button to increase the set(operating)
temperature of the unit,and press the - button to
decrease the set(operating) temperature of the
unit. the temperature setting range is from
16~30℃ (61~86 o F).
4. FAN SPEED button
Select the fan speed LOW, MED, HIGH and TURBO
(This function is applicable to partial of models) in
sequence.
ON/OFF COOL
Temp.
indicator
indicator indicator

5. MODE button

Select the operation mode, COOL,FAN, HEAT.
6. FILTER CHECK indicator
This feature is a reminder of cleaning the air
filter(normal maintenance) for more efficient
operation. The light will turn on automatically
after the fan works more than 250 hours.
If the light is on, turn off and power off the unit,
take the air filter out and clean it, then re-install
the air filter, power on and turn on the unit, the
light will still be on, press + button for 5s,the light
will turn off.
receiver
window
HEAT
indicator