Emptying The Debris Compartment - Bwt Pk Max Manual De Usuario

As soon as the robot reaches the water surface, locate the grip that is underneath the
base and indicated with the hand symbol (see diagram below) to facilitate retrieval from
the pool. Make sure to always grip the robot from this end to prevent debris from falling
back into the pool during retrieval.
.
5. Slide the power switch OFF. Rinse the robot with fresh water after every use. DO
NOT use any detergent.
6. Dry the charging port and pins thoroughly (TIPS: Use cotton bud to dry them)
NOTE: To ensure the most efficient cleaning, when your pool is quite dirty, it is
recommended to empty the debris compartment after the first 30min of operation,
or whenever the robot's movement has slowed down noticeably. Then return the robot
(with an emptied debris compartment) to the pool, and let it run through the remaining of
its cycle.

EMPTYING THE DEBRIS COMPARTMENT

WARNING!
Using the robot without its filter cover in place will VOID your
warranty.
In order to maximize the cleaning efficiency, clean the debris compartment and the filter
cover before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat surface. Pull one side clip outwards to lift one side of the
cover and repeat the steps on the other side to lift the entire top cover to expose the
filter cover.
10/195