Aritech SlimLine 868 GEN2 Manual De Instalación

SlimLine Door/Window Sensor 868 GEN2
Installation Sheet
EN DE EL ES FR IT
1
(1)
(2)
X2
4
EN: Installation Sheet
Introduction
This is the Installation Sheet for models TX-1011-03-1 and TX-
1011-03-3. You can install the sensor on doors, windows, and
many other objects that open and close. The sensor transmits
signals to the control panel when a magnet mounted near the
sensor is moved away from or closer to the sensor.
Encrypted signals help secure RF communication. The sensor
is equipped with a wall and cover tamper for additional
security.
Installation guidelines
Use the following installation guidelines:
•
Mount the sensor on the door frame and the magnet on
the door. If the sensor is used on double doors, mount the
sensor on the least-used door and the magnet on the
most-used door.
•
If possible, locate sensors within 30 m (100 ft.) of the
panel. While a transmitter may have a range of 150 m
(500 ft.) or more out in the open, the environment at the
installation site can have a significant effect on transmitter
© 2022 Carrier
NL PL PT RU TR
2
Z
X1
Y
0.4 in.
(1 cm)
0.4 in.
(1 cm)
3
(T)
(+)
5
(1)
range. Sometimes a change in sensor location can help
overcome adverse wireless conditions.
•
Make sure the alignment arrow on the magnet points to
the alignment mark on the sensor (see Figure 4).
•
Place sensors at least 4.7 in. (12 cm) above the floor to
avoid damaging them.
•
Avoid mounting sensors in areas where they will be
exposed to moisture or where the sensor operating
temperature range will be exceeded. See "Specifications"
on page 3.
•
If possible, mount directly to a stud. If a stud is not
available, use plastic anchors.
•
Remove internal reed switches not in use.
Materials needed
You will need the following tools and materials:
• Two Ø3,5 x 25 mm (#6 x 1.00 in.) PPH (Phillips pan head)
screws and two plastic anchors for mounting the sensor
(included)
• Two Ø3,5 x 15 mm (#6 x 0.625 in.) PPH screws for
mounting the magnet (included)
• One Ø2,5 x 6 mm (#4 x 0.250 in.) PPH screw to secure
the sensor cover to the sensor base (included)
1 / 28
(2) (2) (3)
P/N 466-2110-ML • REV K • ISS 05DEC22
(L)