Operation; Process Variables - Tecno-Gaz Ta009Tau Instrucciones De Uso

Operation

3.2
Set the required sealing edge width. After loosening the knurled screw, the lower insertion
plate can be continuously adjusted for sealing edge widths of 0 - 30mm.
Insert packaging into the device from the left via the insertion plate.
Remove the sealed package on the outlet side and allow to cool down briefly.

Check of the sealing seam
If leaks appear, the sealing temperature must be increased. If the film melts, the set
temperature is too high.
As per DIN 58953 -7, the suitable sealing temperature is to be determined by test
sealing.

Process variables

3.3
Sealing temperature
The temperature is monitored electronically by means of a temperature sensor.
If this varies from the set value by 5°C (requirements set out in DIN 58953-7), the drive is locked.
9.696.160
TecnoSeal TA009TAU
Page 11
Chapter 3
Sealing edge adjustment
Knurled screw
V 1.01