Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
1.
portant safety and operating instructions for the battery charger
MODEL MC9640. You may need to refer to these instructions at a
later date.
CAUTION.
2.
To reduce risk of injury, charge only wet cell, lead-
acid, automotive type rechargeable batteries. Other types of batter-
ies may burst causing personal injury and property damage.
3.
Do not expose the charger to rain or snow if specifically warned on
the unit not to do so.
4.
Use of an attachment not recommended or sold by the battery
charger manufacturer may result in a risk of fire, electric shock, or
injury to persons.
5.
To reduce the risk of damage to the electric plug and cord, pull by
the plug rather than the cord when disconnecting the charger.
6.
An extension cord should not be used unless absolutely necessary.
Use of an improper extension cord could result in a risk of fire and
electric shock. If an extension cord must be used, make sure:
a. That the pins on the plug of extension cord are the same number,
size, and shape as those of the plug on the charger.
b. That the extension cord is properly wired and in good condition.
c. If the length of the extension cord is less than 25 feet, use a 18AWG
cord, if 50 feet-14AWG, 100 feet-12AWG, 150 feet-10AWG.
7.
Do not operate the charger with damaged cord or plug. Replace the
cord or plug immediately.
8.
Do not operate the charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way; take it to a qualified
serviceman.
9.
Do not disassemble the charger unless you are qualified to work on
electrical products. If not, take it to a qualified serviceman when
service or repair is required. Incorrect reassembly may result in risk
of electric shock or fire.
10. To reduce the risk of electric shock, unplug the charger from the
outlet before attempting any maintenance or cleaning. Turning off
the controls will not reduce this risk.
WARNING - RISK OF EXPLOSIVE GASES
11.
a. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGER-
OUS. BATTERIES GENERATE EXPLOSIVE GASES DURING
NORMAL BATTERY OPERATION. FOR THIS REASON IT IS OF
UTMOST IMPORTANCE THAT EACH TIME BEFORE USING
YOUR CHARGER, YOU READ THIS MANUAL AND FOLLOW THE
INSTRUCTIONS EXACTLY.
b. To reduce the risk of battery explosion, follow these instructions,
those published by the battery manufacturer, and manufacturer of
any equipment you intend to use in vicinity of the battery. Review
cautionary markings on these products and on the engine.
027-1063 Rev. 20190321
12V SMART BENCH TOP CHARGER
12.
MADE IN USA
OF U.S. AND
IMPORTED PARTS
This manual contains im-
13.
14.
15.
1
PERSONAL PRECAUTIONS
a. Someone should be within range of your voice or close enough to
come to your aid when you work near a lead-acid battery.
b. Have plenty of fresh water and soap nearby in case battery acid
contacts skin, clothing, or eyes.
c. Wear complete eye protection and clothing protection. Avoid touch-
ing eyes while working near battery.
d. If battery acid contacts skin or clothing, wash immediately with soap
and water. If acid enter eyes, immediately flood eyes with running
cold water for at least 10 minutes and get medical attention
immediately.
e. NEVER smoke, or allow a spark or flame in the vicinity of the battery
or engine.
f. Be extra cautious to reduce risk of dropping a metal tool onto the
battery. It might spark or short-circuit the battery or other electrical
parts that may cause an explosion.
g. Remove personal metal items such as rings, bracelets, necklaces,
and watches when working with a lead-acid battery. A lead-acid
battery can produce a short circuit current high enough to weld a
ring, or the like, to metal, causing a severe burn.
h. Use this charger for charging a LEAD-ACID battery only. It is not
intended to supply power to a low-voltage electrical system other
than in an automotive application. Do not use this battery charger for
charging dry-cell batteries that are commonly used with home appli-
ances. These batteries may burst and cause injury to persons and
damage to property.
i. NEVER charge a frozen battery.
PREPARING TO CHARGE
a. If necessary to remove battery from vehicle to charge, always re-
move the grounded terminal from the battery first. Make sure all
accessories in the vehicle are off, so as not to cause an arc.
b. Be sure the area around the battery is well ventilated while the bat-
tery is being charged. Gas can be forcefully blown away by using a
piece of cardboard or other non-metallic material as a fan.
c. Clean the battery terminals. Be careful to keep corrosion from com-
ing in contact with eyes.
d. Add distilled water in each cell until battery acid reaches level speci-
fied by the battery manufacturer. This helps purge excessive gas
from cells. Do not overfill. For a battery without cell caps, carefully
follow the manufacturer's recharging instructions.
e. Study all battery manufacturer's specific precautions such as remov-
ing or not removing the cell caps while charging and the recommend-
ed rates of charge.
f. Determine voltage of the battery by referring to the car owner's man-
ual and make sure that the output voltage selector switch is set at the
correct voltage. If the charger has adjustable charge rate, charge the
battery initially at the lowest rate.
CHARGER LOCATION
a. Locate the charger as far away from the battery as the DC cables
permit.
b. Never place the charger directly above the battery being charged;
gases from the battery will corrode and damage the charger.
c. Never allow battery acid to drop on the charger when reading the
specific gravity, or filling the battery.
d. Do not operate the charger in a closed-in area, or restrict ventilation
in any way.
e. Do not set a battery on top of the charger.
DC CONNECTION PRECAUTIONS
a. Connect and disconnect the DC output clamps only after setting the
charger switch to the OFF position and removing the AC cord from
the electric outlet. Never allow the clamps to touch each other.
b. Attach the DC clamps to the battery post and twist or rock back and
forth several times to make a good connection. This tends to keep
the clamps from slipping off the terminals and helps to reduce the
risk of sparking.
MC9640
1903091-11

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Matco Tools MC9640

  • Página 1 If necessary to remove battery from vehicle to charge, always re- MODEL MC9640. You may need to refer to these instructions at a move the grounded terminal from the battery first. Make sure all later date.
  • Página 2 MC9640 12V SMART BENCH TOP CHARGER FOLLOW THESE STEPS WHEN THE BATTERY IS DANGER: Never alter the AC cord or plug provided. If it will not fit INSTALLED IN A VEHICLE. A SPARK NEAR THE the outlet, have a proper outlet installed by a qualified electrician.
  • Página 3: Operating Procedure

    MC9640 12V SMART BENCH TOP CHARGER OPERATING INSTRUCTIONS: CHARGING OPERATION: a. Connect the deeply discharged battery to charger, battery should be • SLOW BLINKING RED LIGHT - Indicates possible weak bat- placed as far away from the charger as the cables will allow (See tery.
  • Página 4: Maintenance Instructions

    MC9640 12V SMART BENCH TOP CHARGER MAINTENANCE INSTRUCTIONS Worn clamps and jaws should be replaced. Worn parts can lead to poor connections and present a safety hazard. See parts list for part number of jaw and clamp kits. Any maintenance or repair of this unit that involves disassembly of the cabinet should be done only by a qualified service personnel.
  • Página 5: Cargador Inteligente De Banco 12V

    MC9640 CARGADOR INTELIGENTE DE BANCO 12V b. Para reducir el riesgo de una explosión de la batería, siga estas instrucciones y las publicadas por el fabricante de la batería y el fabricante de cualquier equipo que vaya a utilizar cerca de la batería.
  • Página 6: Instrucciones De Conexión Del Cable Ac Atierra

    MC9640 CARGADOR INTELIGENTE DE BANCO 12V SIGA ESTOS PASOS CUANDO LA BATERÍA ESTE PELIGRO: Nunca altere el cable AC o el enchufe-Si no se ajusta, INSTALADA EN EL VEHÍCULO. UNA CHISPA CER- necesita ser instalado por un electricista profesional. Conexiones incorrectas pueden causar riesgo de shock eléctrico.
  • Página 7 MC9640 CARGADOR INTELIGENTE DE BANCO 12V INSTRUCCIONES DE OPERACIÓN MANEJO: a. Conecte al cargador la batería excesivamente descargada; la batería • LUZ ROJA INTERMITENTE LENTA - Indica que la batería debe colocarse lo mas dentro posible según lo permitan los cables.
  • Página 8: Instrucciones De Mantenimiento

    MC9640 CARGADOR INTELIGENTE DE BANCO 12V INSTRUCCIONES DE MANTENIMIENTO Pinzas y mordazas deterioradas deben ser reemplazadas. Las par- tes deterioradas causan malas conexiones y pueden ser un peligro para su seguridad. Vea la lista de piezas para el número de kits de pinzas y mordazas.
  • Página 9 MC9640 CHARGEUR DE BANC INTELLIGENT 12V AVERTISSEMENT - DANGER DÛ AUX GAZ EXPLOSIFS a. IL EST DANGEREUX DE TRAVAILLER PRÈS D'UNE BATTERIE AU PLOMB EN RAISON DES GAZ EXPLOSIFS PRODUITS LORS DU FONCTIONNEMENT NORMAL DE LA BATTERIE. POUR CETTE RAISON, IL EST DE LA PLUS HAUTE IMPORTANCE DE LIRE SOIGNEUSEMENT ET D'OBSERVER LES INSTRUCTIONS DU PRÉSENT MANUEL AVANT TOUTE UTILISATION DU CHAR-...
  • Página 10: Emplacement Du Chargeur

    MC9640 CHARGEUR DE BANC INTELLIGENT 12V EMPLACEMENT DU CHARGEUR c. Brancher la pince positive (ROUGE) du chargeur à la borne positive (POS, P, +) de la batterie. a. Installer le chargeur aussi loin de la batterie que les câbles cc. le d.
  • Página 11: Période De Charge

    MC9640 CHARGEUR DE BANC INTELLIGENT 12V PÉRIODE DE CHARGE g. Le temps de chargement dépend de la taille et de l’état de décharge- ment de la batterie. Le période de charge complète approximative d’une batterie dépend h. Une fois le chargement termine, un signal sonore est émis et le du nombre d’ampères-heures en multipliant le nombre d’heures par...
  • Página 12: Instructions D'entretien

    Interrupteur ............... 610263 Pieces non visibles Poignée ................. 6202 Pinces (1 paire avec mâchoires)........6199 Jeu de mâchoires (répare 1 pince) ......610970 SCHEMA DE CABLAGE Fan Out AC Transf Matco Tools Stow, Ohio 44224 www.matcotools.com 027-1063 Rev. 20190321 1903091-11...

Tabla de contenido