Uline H-675 Funcionamiento

π
H-675, H-676
TAPE AND LABEL
DISPENSER
Tape Cutter with Guards
Upper Metal Bar with Spring
LABELS
1. Unlock load-and-lock bar by rotating both plastic
knobs toward the front of dispenser.
(See Figure 1)
2. Pull load-and-lock bar until in fully-forward position.
3. Set rolls of labels on base bar so labels unroll toward
the front of the dispenser with adhesive side facing
down.
4. Pull end of roll about 10" forward under the upper
metal bar with spring and over lower metal bar.
5. If using more than one roll of labels on dispenser,
install roll separators between rolls.
6. Push load-and-lock bar back into original position
and rotate plastic knobs backward to lock.
(See Figure 2)
7. Pull end forward slowly to dispense label from liner.
NOTE: If using with tape, see next page.
PAGE 1 OF 6
1-800-295-5510
uline.com
Base Bar
Upper Metal Bar
Lower Metal Bar
OPERATION
Figure 1
Load-and-Lock Bar
Upper
Metal Bar
Upper
Metal Bar
with Spring
Figure 2
Label
Liner
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Load-and-Lock Bar
Labels
Lower Metal Bar
Lock
1121 IH-675