Uline H-8280 Manual Del Usuario

H-8280, H-8281
STANDING HEIGHT TABLE
TOOLS NEEDED
Phillips
Screwdriver (optional)
Camlock Pin x 25
NOTE: Assemble on smooth, non-marring
surface to avoid scratching.
NOTE: Use Phillips screwdriver to tighten
camlock pins, camlocks and screws.
NOTE: The four wood screws come
packaged with power center. (H-8281 only)
IMPORTANT! Check that all parts are included.
IMPORTANT! The arrow on the camlock (B) must
point toward the camlock pin (A) for proper
alignment. Turn camlock clockwise until it locks
with pin.
1. Install camlock pins (A) and insert dowels (C) in
leg panels. (See Figure 1)
2. Insert camlocks (B) into corresponding holes on
modesty panels. (See Figure 1)
PAGE 1 OF 6
Three Person Assembly
Recommended
Drill
Leg Panel x 2
Camlock x 25 Dowel x 13
1-800-295-5510
uline.com
PARTS
Tabletop Panel x 1
Camlock Sticker x 25
ASSEMBLY
3. Fit leg panels and modesty panels together and
turn each camlock (B) clockwise until it locks.
(See Figure 1)
Figure 1
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Modesty Panel x 2
Adhesive-Backed Wood Screw x 4
Cable Clip x 5 (H-8281 only)
A
C
B
Modesty
Panels
Leg Panels
0821 IH-8280