Uline H-9143 Guía Rápida

H-9143, H-9144, H-9145
H-9146, H-9147, H-9148
HON FABRIC PARTITION
TOOL NEEDED
1/2" Wrench
1. Unscrew leveling glide and nut
from bottom of panel.
(See Figure 1)
2. Insert leveling glide and nut through T-Base leg and
into bottom of panel frame. (See Figure 2)
NOTE: Hole in
T-Base leg is
off-center. Position
leg so that hole is
located closer to
outside of panel.
PAGE 1 OF 3
1-800-295-5510
uline.com
T-Base Leg x 2
Panel x 1
ASSEMBLY
Figure 1
Figure 2
PARTS
Leveling Glide
and Nut x 2
3. Tighten leveling glide and nut using wrench.
(See Figure 3)
Figure 3
4. Repeat on opposite side of panel.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0221 IH-9143