Matco Tools MT2883L Instrucciones De Operación

• Operating Instructions • Warning Information
Max. Free Speed ................................................................................. 18,000 RPM
Collet Size ..........................................................................................................1/4"
Air Inlet ..................................................................................................... 1/4" NPT
Air Hose Size ............................................................................................... 3/8" ID
Recommended Air Pressure ...................................................................... 90 PSIG
Length ............................................................................................................. 10.6"
Weight....................................................................................................... 2.4 LBS.
Average Air Consumption ...........................................................................4.0 CFM
Sound Pressure Level .................................................................................. 82 dBA
important lubrication instructions
Lubricate wick system through angle gear head oil
fitting with three plunges every 8 hours of use for
maximum gear life.
important:
• Use 140 weight lube oil only for wick system.
• Do not contaminate wick with any other oil or
grease product.
140 weight
lube oil
• MAxiMuM rpM of 18,000
• MAx Air preSSure: 90 pSig,
6.2 bAr
• rpM of The AcceSSorY
MuST exceed Tool rpM
AlwAYS reAd
inSTrucTionS
before uSing
power ToolS
AlwAYS weAr
SAfeTY goggleS
weAr heAring
proTecTion
Avoid
prolonged
expoSure To
vibrATion
MT2883L
MT2883L_Manual_052407.indd 1
• Parts Breakdown
S P E C I F I C A T I O N S
.
Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities contains chemicals known to cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
MT2883L
Copyright © Professional Tool Products, 2007

®
MT2883L
.50 HP Extended
Right Angle
Die Grinder
All rights reserved
05/24/07
5/25/07 11:39:00 AM