Uline H-4979 Instalación

H-4979, H-4980
MOUNTING SOCKET FOR
SAFETY RAILINGS
TOOLS NEEDED
7/16" Diameter
Masonry Drill Bit
1. Verify the mounting socket is positioned in the desired
location. Mark the floor where holes will be drilled.
WARNING! Wear eye protection when
completing step 2.
2. Using a 7/16" diameter masonry drill bit, drill a hole
2⁄" deep into the floor. (See Figure 1)
NOTE: For the anchor to function properly, the
hole must not be larger in diameter than the
anchor bolt.
Figure 1
Anchor
7/16"
Masonry
Drill Bit
PAGE 1 OF 6
Eye Protection
Bolt
1-800-295-5510
uline.com
Hammer
INSTALLATION
3. Clean out debris and dust from inside the hole. Fully
insert the anchor bolt through the mounting socket and
into the hole.
NOTE: Thread washers and nut onto anchor
bolt. Nut should be tightened halfway between
end of bolt and top of anchor sleeve.
(See Figure 2)
Figure 2
4. Tap down anchor bolt with a hammer. (See Figure 3)
5. Repeat for remaining anchors. Tighten the 14 mm
hex nut until the anchor bolts are secure.
Figure 3
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
3/8" Wrench 14 mm Wrench
Tighten Not all the
halfway way tight
X X
Not all the
way loose
0621 IH-4979