Uline H-2888 Guia De Inicio Rapido

H-2888
6' RECYCLED PLASTIC
BENCH WITH BACK
TOOLS NEEDED
Power Drill
Double Holed Bullnose
6' Bench Slat x 2
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
7/16" Socket Bit
Single Hole 6' Bench Slat x 5
PARTS
Bench Base x 3
ASSEMBLY
NOTE: It is important to keep screws loose
throughout assembly. Tighten during step 7.
1. Verify all parts are present before beginning.
2. Place the three bench bases on a flat, level surface.
3. Align a double holed bullnose bench slat on the
front set of pre-drilled holes on the bench base seat.
Loosely attach bench slat to the bench bases with
the 3½" lag screws and washers using the power drill
and 7/16" socket bit (will tighten later in step 7). (See
Figure 1)
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Washers x 27
3⁄" Lag Screws x 27
0621 IH-2888