Uline H-3745 Instrucciones De Ensamble

π H-3745
6' ALUMINUM
PICNIC TABLE
TOOLS NEEDED
Power Drill
Aluminum Plank x 5
Metal End Caps for Seats x 4
Metal End Caps for Tabletop x 2
1. Lay three aluminum planks side by side, upside
down, on a flat surface to form the tabletop. Slide
the metal caps onto each end. One end cap
covers the three planks. The pre-drilled holes of the
end cap should be facing up. Use power drill and
two self-tapping
screws to secure
each metal end
cap onto each
end of the tabletop.
Loosely attach the
center support brace,
centered, onto the
middle tabletop plank
using two hold down
clips, two 5/16" flange
nuts and two 5/16"
carriage bolts.
(See Figure 1)
PAGE 1 OF 6
1-800-295-5510
uline.com
Socket Wrench
5/16" x 1½" Carriage Bolts x 22
5/16" Flange Nuts x 22
ASSEMBLY INSTRUCTIONS
Center Support Brace
Hold Down Clip
Metal End Cap
Figure 1
PARTS
3/8" x 1⁄" Hex Head Bolts x 3
3/8" Flange Nuts x 3
Center Support Brace x 1
Diagonal Brace x 2
2. For the seats, lay two aluminum
planks upside down on a flat
surface. Slide the metal end caps
onto each end of the planks.
The pre-drilled holes of the end cap
should be facing up. Use power
drill and two self-tapping screws to
secure each end cap onto each
end of the plank.
(See Figure 2)
3. Loosely attach both
diagonal braces to
both leg frames using
one 3/8" flange nut
and one 3/8" hex head
bolt per leg frame.
(See Figure 3)
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Leg Frame x 2
Hold Down Clips x 22
3/16" Self-Tapping
Screws x 12
Diagonal
Brace
Figure 3
Figure 2
1120 IH-3745