Echo P021007010 Instrucciones De Montaje

BRUSH INSTALLATION
Level 1.
Tools Required: 8 mm Open End Wrench, Cross Head Screwdriver
Parts Required: Brush Kit P/N P021007010 Qty. (2)
Brushes that are broken off, deformed or worn to within 25.4 mm (1 in.)
of the brush holder drum should be replaced for best sweeping effi-
ciency.
1. Locate brush holder access hole (A) near outer drum end.
2. Hold 8 mm nut (B) from turning with open end wrench inserted
through drum holder cap. Loosen and remove bolt and lock nut
with cross head screwdriver through holder access hole (A).
3. Remove drum cap (C). Slide brush holder drum off square axle shaft.
4. Install new brush holder drum aligning hole (A) in drum axle with
axle shaft hole.
5. Install drum cap aligning cap holes with axle shaft and brush holder
drum holes.
6. Install bolt and locknut. Tighten securely.
SUP22203699
ASSEMBLY INSTRUCTIONS FOR
PROSWEEP BRUSH KIT
P/N P021007010
A
C
1
B
A
99922203699
07/03
C