STAR Water Systems sw0928 Guia De Inicio Rapido

SUMP PUMP
MODEL 022488, 022489
022490
QUICK REFERENCE
GUIDE.
SEE INSTRUCTION
MANUAL FOR
COMPLETE DETAILS.
WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
2
Check valve
4
Grounded
outlet
Install a full flow
check valve to
prevent back flow
and increase pump
life.
Plug in pump and
restore electrical
power at the service
entrance.
Fill sump pit with
water to check
automatic switch
operation.
© 2014. All rights reserved.
1
Discharge pipe
Float switch
3
Vent hole
5
Sump basin
cover
SW0928 0714
Supersedes NEW
Remove any
sediment, debris,
and or standing
water from the
sump basin.
Place the pump in
the sump basin and
attach the discharge
piping.
Be sure that the
pump is positioned
so that the float
switch moves freely
without touching the
wall of the sump or
other obstructions.
Drill a 3/16 in. vent
hole in discharge
pipe below the sump
basin cover and
check valve. A water
stream will be visible
from this hole when
the pump runs.
Install a sump basin
cover. A cover will
prevent solid matter
from falling into the
sump basin, prevent
odors, and guard
against accidental
injury.