GM 84263456 Instrucciones De Montaje

Splash Guard - Front
Please read instructions thoroughly before starting.
Tools Required
• Socket wrench
• 7 mm Socket
• Plastic Trim Removal Tool
• Clean Cloth/Rag
Parts Required from Package Contents
Description Quantity
Left Hand Splash Guard
Right Hand Splash Guard
Front Installation Procedure
Note: Do not use power tools to install splash guard fasteners
1. Turn front tire to provide clearance.
2. Clean and degrease body panel where splash guards are to
be located.
3. Use 7 mm socket to remove screw in location (A). Retain
fastener. See Fig. 1.
4. Use plastic trim removal tool to dislodge the existing stone
protector panel clips from fender. Remove the existing stone
protector. Take care not to damage paint. See Fig. 2.
5. Guide splash guard tabs into wheel liner slots. See Fig. 3.
6. Align splash guard clips with clip insertion holes and snap
splash guard in. See Fig. 3.
7. Reinstall fastener in location (A). See Fig. 4.
8. Repeat procedure for the other side.
9. Guards can be cleaned with any commercially available
cleaner.
NOTE: Max torque on M4.2 Screw is 3.0 N m
Splash Guard - Front
1
1
FIGURE 1
VIEW
FROM
BELOW
EXISTING
SCREW
FIGURE 3
TABS
84263456
IR 18FE19
PART NO.
6200 Grand Pointe Dr., Grand Blanc, MI 48439
FIGURE 2
FIGURE 4
VIEW
FROM
BELOW
EXISTING
SCREW
1
SHEET OF
3