GM 84263460 Instrucciones De Montaje

Splash Guard - Rear
Please read instructions thoroughly before starting.
Tools Required
• Socket wrench
• 7 mm Socket
• Plastic Trim Removal Tool
• Clean Cloth/Rag
Parts Required from Package Contents
Description Quantity
Left Hand Splash Guard
Right Hand Splash Guard
Rear Installation Procedure
Note: Do not use power tools to install splash guard fasteners
1. Clean and degrease body panel where splash guards are to
be located.
2. Use 7 mm socket to remove screw in location (A). Retain
fastener. See Fig. 1.
3. Use plastic trim removal tool to dislodge clips from rear fascia
and remove existing stone protector. Take care not to damage
paint. See Fig. 2.
4. Align and then insert the splash guard tab to the wheel liner
slit. See Fig. 3.
5. Align splash guard clips with clip insertion holes and snap
splash guard in place. See Fig. 3.
6. Reinstall fastener in location (A). See Fig. 4.
7. Repeat procedure for the other side.
8. Guards can be cleaned with any commercially available
cleaner.
NOTE: Max torque on M4.2 Screw is 3.0 N m
Splash Guard - Rear
1
1
FIGURE 1
VIEW
FROM
BELOW
EXISTING
SCREW
FIGURE 3
TAB
84263460
IR 18FE19
PART NO.
6200 Grand Pointe Dr., Grand Blanc, MI 48439
FIGURE 2
FIGURE 4
VIEW
FROM
BELOW
EXISTING
SCREW
1
SHEET OF
3