STAR Water Systems 40EC Guía De Referencia Rápida

SEWAGE PUMP
MODEL 40EC, 451558, S1267
QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR
COMPLETE DETAILS.
Toll Free Help Line
1-800-742-5044
Your septic system is not a trash can! Do not pump:
Excessive chlorine or bleach "Flushable" wipes
Salt brines Paper towels
Latex or oil paint & thinners Dental floss
Herbicides & pesticides Feminine hygiene products
Oils & body lotions Hair
Septic tank "enhancers" Rubber gloves
Caustic drain openers Condoms
Motor oil Cat litter
3
Secure power cord to discharge pipe and plug into a GFCI-protected
outlet.
© 2020. All rights reserved.
1
Place pump securely in minimum 18 in. x 30 in. basin on a solid
surface such as a cement block.
Excessive kitchen grease
Egg shells
Fruit & vegetable peels
Cement
Coffee filters & grounds
Block
Seeds
Cooking oil
Onion skins
Sink-ground garbage
4
Add water to basin to test operation. Pump should turn on and off at
these approximate levels.
GFCI-
protected
receptacle
Model
40EC
S1267
30 in.
18 in.
Off
On Level Level
12-1/2" 4-1/2"
12" 4"
2
Drill a 3/16 in. hole in the discharge pipe, level with the top of pump.
Pumps have a vent located in the pump, but an additional vent hole
is recommeded.Connect 2 in. discharge pipe with vent hole, union,
check valve and gate valve to main waste line.
Main
Waste Line
Check
Valve
Vent hole
located in
the pump
housing
5
Seal basin with lid and install vent pipe per codes.
Vent
Pipe
Gate Valve
Union
Additional
3/16-in.
Vent Hole
SW1620 A