STAR Water Systems UTHALC Guia De Inicio Rapido

SUBMERSIBLE UTILITY PUMP
MODEL #UTHALC, 2STHALC, 3STHALC,
QUICK START GUIDE. SEE INSTRUCTION
MANUAL FOR COMPLETE DETAILS.
2. Place pump in
the water on a
hard surface.
Pump will operate
continuously
whether
partially or fully
submerged. Avoid
placing pump
directly on sand,
dirt, or mud.
Pump has an air
4.
valve to prevent air-
locking. Air-locking
will keep pump
from pumping
water. A small
spray of water from
the air valve is
normal and does
not represent a
defective pump.
6. DO NOT RUN
DRY. Running
pump when it is
not submerged
in water will
damage the seal
and impeller,
and void the
warranty.
Toll Free Help Line: 1-800-742-5044
433039, 473685
Hard
Surface
Normal
Water
Spray
DO NOT
RUN DRY!
1. Attach garden hose
adapter (B) to the pump
discharge and then
connect garden hose (not
included) to adapter (B).
DO NOT OVERTIGHTEN
THE GARDEN HOSE OR
HOSE ADAPTER. Hand
tight plus an additional
1/4 to 1/2 turn should be
sufficient.
Plug pump
3.
into a properly
grounded 115 V
AC power outlet.
5. When the water
level at bottom
of pump drops
to approximately
3/16 in., pump will
continue to run
but will stop mov-
ing water. Unplug
pump when water
stops flowing from
the hose.
IL1774A
WARNING:
FOR YOUR PROTECTION, ALWAYS
DISCONNECT PUMP FROM POWER
SOURCE BEFORE HANDLING.
NOT DESIGNED FOR CONTINUOUS,
ONGOING OPERATION. DESIGN LIFE IS
4,500 ACCUMULATED HOURS.
IL1772
GFCI Outlet
RESET
Unplug
TEST
Pump
Low Water
SW1408 B