Behringer OVERDRIVE DISTORTION OD300 Guia Del Usuario

OVERDRIVE/DISTORTION OD300
2-Mode Overdrive/Distortion Effects Pedal
(5)
(1)
(2)
(8)
Thank you for showing your confidence in us by purchasing the
Behringer OVERDRIVE DISTORTION OD300. This effects pedal is ideally
suited for electric guitars. Thanks to its high-performance features you
can create state-of-the-art overdrive, distortion or a combination of
both effects.
1. Controls
The LEVEL control adjusts the output level.
(1)
The TONE control allows you to shape your overall sound.
(2)
The DRIVE control adjusts the intensity of the overdrive/
(3)
distortion effect.
Use the MODE control to adjust the balance between overdrive
(4)
and distortion effect. In leftmost position you got pure overdrive
effect and in the rightmost position you get pure distortion.
The ON/BATT LED illuminates when the effect is activated. It also
(5)
serves as a battery level indicator.
Use the footswitch to activate/deactivate the effect.
(6)
Use this ¼" TS IN connector to plug in the instrument cable.
(7)
The ¼" TS OUT connector sends the signal to your amp.
(8)
Use the DC IN connection at the front of the unit to plug in a 9 V power
supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
◊ ◊
The OD300 has no on/off switch. As soon as you insert the
jack into the in connector, the OD300 begins running. When
not using the OD300, remove the jack from the in connector.
This extends the life of the battery.
V 1.0
(4)
(3)
(7)
(6)