HON 107318NN Manual Del Usuario

107 "L" WORKSTATION STACK-ON UNIT
Illustration 1
Front of
end panel
Minifix bolts (four
each end panel)
Illustration 2
Top assembly
Arrow (point
toward outer
edge of top
assembly)
Illustration 3
Top assembly
End panel
Read all instructions and review illustrations
before installing.
Mounting plate
(two each end
Tools required for assembly:
panel)
Phillips screwdriver
Tape measure
This assembly includes:
(1) Top assembly
(2) Door
(4) Hinge
(2) Desk bracket
(10) Dowel
(8) Minifix bolt
(1) Mounting tape
Dowels (five
each end
panel)
Wood products are heavier than they appear
and may be hard to control when moving.
Use two or more people when moving wood
products or severe personal injury may
result.
Hardware pack is taped underneath stack-on
unit. Be sure to locate hardware pack before
discarding any packaging materials.
Assembly:
1. Refer to Illustration 1. Insert minifix bolts (from
hardware pack), four each end panel, and
slowly tighten. Do not over-tighten.
2. Refer to Illustration 1. Insert dowels (from hard-
Minifix cam (four
each side of top
ware pack), five each end panel. Tap lightly
assembly)
with a rubber mallet to fully seat.
3. Refer to Illustration 2. Insert minifix cams (from
hardware pack) into their respective holes. The
arrow on the minifix cam should point toward
the outer edge of top assembly.
4. Refer to Illustration 3. Attach an end panel to
top assembly by aligning minifix bolts and dow-
els with their respective holes and push togeth-
er. Tap lightly with a rubber mallet.
5. Turn minifix cams clockwise approximately
turn to secure. Do not over-tighten. Install con-
nector covers (from hardware pack).
6. Repeat Steps 1 through 5 for remaining end
panel.
Rubber mallet
Masking tape
(1) Right end panel
(1) Left end panel
(4) Mounting plate
(2) Wood screw
(8) Minifix cam
(30) Connector cover
WARNING
IMPORTANT
SIDE 1 OF 4 (2/05)
1 /
2
242-7418C