HON HON115292AXNN Instrucciones De Instalación

Illustration 1
Cam bolt
Shoulder
Right end
panel
Illustration 2
Cam bolt
Back
Illustration 3
Cam connector
Back
LATERAL FILE BOOKCASE
Dowel
Left end
panel
Top edge
Top edge
Arrow
Left end panel
Read all instructions and review illustra-
tions before installing.
Tools required for assembly:
Phillips screwdriver
Rubber mallet
Masking tape
Cam bolt
Tape measure
This assembly includes:
(1) Left end panel
(1) Right end panel
(1) Top
(2) Adjustable shelf
(1) Back
(2) Reveal
(9) Cam bolt
(9) Cam connector
(8) Dowel
(8) Fastener pin
(-) Mounting tape
Left end
panel
Wood products are heavier than they
appear and may be hard to control when
moving. Use two or more people when
moving wood products or severe person-
al injury may result.
Heavy panels can pinch or crush fingers.
Do not place fingers between or under
panels during assembly.
Bookcase Assembly:
1. Refer to Illustration 1. Lay end panels, with
holes up, on cardboard or a carpeted sur-
face.
Use the Phillips screwdriver to install cam
bolts (from hardware pack) into end panels
as shown. Tighten cam bolts until cam bolt
shoulder is flush against surface of end
panels.
Use the rubber mallet to install dowels (from
hardware pack) into the locations shown.
2. Refer to Illustration 2. Attach back to left end
panel. Insert end panel cam bolts into holes
in side of back. Ensure top edge of back
and end panel are facing down.
3. Refer to Illustration 3. With arrows facing
end panel, install cam connectors (from
hardware pack) into holes along side of
back. Use the Phillips screwdriver to tighten
cam connectors. Turn cam connectors
clockwise to tighten.
WARNING
SIDE 1 OF 4 (9/04)
242-7670B