peerless-AV PM 610 Instalación Y Montaje

Installation and Assembly -
Read instruction sheet before you start installation and assembly.
• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete
surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica-
tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to
avoid breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware
and components.
IMPORTANT! Turn to the appropriate page for your wall installation.
Installations:
To Wood Stud Walls ........................................................................................................ page 2
To Solid Concrete, Cinder Block, and Brick Walls ........................................................ page 3
Visit the Peerless Web Site at www.peerlessindustries.com
Electronics Tower
WARNING
1 of 10
Maximum Load Capacity (Each Shelf):
15.00 lb (7.0 kg)
PUBLICATION: 12-20-99 SHEET#: 021-9003-3 03-23-05
For customer service call 1-800-729-0307 or 708-865-8870.
Model: PM 610
PM 610S
PM 610W