ResMed H5i Guia De Inicio Rapido

H5i™ Standard Water Tub
User Instructions
English • Français • Español • Português
A
1
3
5
English
You should regularly carry out cleaning and
maintenance of the standard water tub as
described in this section.
Disassembling the H5i water tub
Refer to illustration A.
1. Slide the latch.
2. Lift open the flip lid.
3. Remove the water tub.
Discard any excess water from the water tub.
4.
5. Unclip all four side latches.
2
Pull apart the tub lid and base.
6.
Daily cleaning
1. Wash the disassembled tub lid and base in
warm water using a mild detergent.
2. Rinse thoroughly in clean water and allow
them to dry away from direct sunlight.
Monthly cleaning
Peel the flip lid seal from the flip lid and wash it
1.
4
in warm water using a mild detergent.
2. Wipe the exterior of the H5i with a damp cloth
and mild detergent.
Maintenance checklist
Inspect the water tub and flip lid seal for wear
9
and deterioration.
Replace the water tub if any component is
9
leaking or has become cracked, cloudy or
pitted.
6
Replace the flip lid seal if cracked or torn.
9
Clean white powder deposits in the water
9
tub by using a solution of one part household
vinegar to 10 parts water.