Rola 59504 Manual De Instrucciones página 2

Please read all instructions carefully before assembly, installation and/or use of this product.
1
RUBBER
GASKETS
ROLL GASKETS
BACK UPON
THEMSELVES
RUBBER
GASKETS
SCREW HOLES
2
Rubber Washer
Screw, #10-32 (Self Tapping)
ATTACH AIR DEFLECTOR
•
Line up the holes in air deflector with the four holes in the front cross tubes of cargo carrier basket. Install four #10 self-
tapping screws with rubber washers as shown. Tighten screws until the rubber washers start to compress – DO NOT
OVER TIGHTEN!
3
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Product Name:
LOCATOR TUBES
SELF-TAPPING SCREWS
(4) PLACES
cross bars
Roof Top Carrier
Product Code:
59504
ASSEMBLE CARGO CARRIER
•
To assemble the cargo carrier basket, place the two
halves of basket on a flat non-marring surface.
•
Apply a small amount of rubber-safe lubricant on
the inside of each rubber gasket.
•
Slide the rubber gaskets over the locator tubes.
•
Rolling the gaskets back upon themselves as
shown, expose the screw holes in the locator tubes.
•
Line up the holes in locator tubes with the slots in
remaining half of cargo basket for minimum seam
gap.
•
Secure locator tubes with self-tapping screws.
•
Unroll the rubber gaskets, making sure that they
cover the heads of the screws.
POSITION CROSS BARS
•
Adjust your cross bars to one of (4) four
available settings:
• 37-1/2" center to center
• 33-3/4" center to center
• 30" center to center
• 26-1/4" center to center – Minimum
•
NOTE: It is recommended to use the
widest setting for optimum load
distribution.
•
Leave cross bars loose at this step.
www.rolaproducts.com
Page 2
59504N Rev. F 6-3-14