Stryker TPS2 Instrucciones De Armado

TPS2 STAND ASSEMBLY INSTRUCTIONS
Item
1 Steel Base
Washer
2
3 Tube
LG Basket
4
5 Mount Blocks
7 Washer
Cap Nut
8
9 Screw
10 Mount Plate
Screw
11
12 Bolt
Wrench
NOT
SHOWN
Carton
Instruction Sheet
PROCEDURE
1. Press tube onto base. Secure with washer and screw.
2. Place mounting blocks around tube. Blocks should be placed over the locating pin near the top of the tube.
3. Place the screws through the mount plate and mount blocks. The posts on the mount plate must be on the top.
Secure with the washer and cap nut.
Position the T/Pump ® between the posts on the bracket. T/Pump
included screws.
CLEANING
The TPS2 stand can be cleaned with a damp cloth and mild detergent.
WARRANTY
Stryker equipment and products are warranted against defects in material and workmanship under normal use, and
operation from the date of purchase, for the time periods listed below for the respective equipment and products. Except
for such warranty, Stryker disclaims all other expressed and/or implied warranties including, but not limited to, the implied
warranties of merchantability and of fitness for a particular purpose.
All labor performed and parts provided free of charge for a period of one (1) full year from the date of purchase, provided
the equipment is returned with prior authorization prepaid to Stryker Industries.
www.stryker.com
PARTS LIST
Description Qty
1
1
1
1
2
2
2
2
1
2
1
PACKAGING
1
1
1
101185 REV C.0
® can be permanently affixed to the bracket with the
English
1