OHAUS a-AB33M1 Guia De Inicio Rapido

Switch On/Off
Off
On
EC Cell K Setup
Note: Please set the Cell K value first before EC calibration.
EC TDS Factor Setup
EC Reference Temperature Setup
EC Temperature Coefficient Setup
pH Buffer Solution Setup
Note: Please check the pH buffer group table on the back of the page for details of the buffer values.
EC Standard Solution Setup
Note: Predefined standard solution: 10 μS/cm, 84 μS/cm, 146.5 μS/cm, 500 μS/cm, 1413 μS/cm, 12.88 mS/cm. Please set the Standard Solution first before EC calibration.
pH Calibration (Continuous)
Press the button when
you finish to continue.
EC Calibration (Continuous）
Press the button when
you finish to continue.
pH Measurement
Touch the mode area on the
screen to select measurement
Insert the probe into a sample.
mode.
EC Measurement
Touch the mode area on the
screen to select measurement
Insert the probe into a sample.
mode.
Temperature Unit Setup
Temperature Setup
Switch pH/mV/ORP Mode
PH
Switch EC/TDS/SAL/RES Mode
EC
st
Calibrating (1 point)
Calibrating
Measuring
Measuring
MV
TDS
Touch Finish to complete
Completed
calibration or touch Next to
perform a 2
The calibration result will be
Touch Finish to complete
shown when you finish.
calibration.
Completed
Completed
ORP
SAL RES
Touch the value on the screen
to confirm your setting.
Touch the value on the screen
to confirm your setting.
Touch the value on the screen
to confirm your setting.
Calibration
Touch the Calibration icon on the screen and
follow the following procedures to perform pH
or EC calibration.
The calibration result will be
shown when you finish.
nd
calibration.
Print
Print:
Touch the Printer icon
on the screen to print.
Store/Recall Data
Recall measurement data:
Touch the Beaker icon on the
screen to recall.
Note: measurement data will
be automatically stored after
each operation.
Touch the value on the screen
to confirm your setting.