Kohler K-4615 Guia De Instalacion

INSTALLATION GUIDE
Tools Needed:
Wrench
Install the Toilet Seat
Snap open the two hinged lids, or caps, that cover the seat bolt holes.
Slip the metal washers on the bolts, and fit the bolts through the hinges
from the top. Fit the rubber or foam gaskets on the bolts.
Position the seat on the toilet so the bolts fit through the toilet seat-mount
holes.
CAUT ION: Risk of product damage. Do not overtighten the bolts.
Hand tighten the bolts if the toilet is equipped with pre-installed
metal nuts.
If the toilet seat-mount holes do not have pre-installed metal nuts,
loosely thread the nuts on the bolts.
Tighten the bolts from the top, holding the nuts if necessary. Center
the seat as needed.
Snap the hinged lids, or caps, closed.
Care and Cleaning
Clean the outside surface of your toilet seat with mild soap, such as liquid
dish soap and warm water. Wipe the entire surface completely dry with a
clean soft cloth. Do not use any abrasive cleaners, as they will scratch and
dull the surface. Avoid any detergents, disinfectants, or cleaning products
in aerosol cans. Avoid contact with abrasive chemicals and cosmetics,
such as fingernail polish and aftershave, as they may damage the finish of
your toilet seat.
kohler.com
K-4615, K-4617, K-4622, K-4665,
Caps
Seat
Gasket
Metal Nut
Toilet Seat
Mounting Holes
1
TOILET SEAT
K-4701, K-4755, K-4756
Bolts
Metal Washer
Gasket
Nut
1007299-2-J