Climbing Technology EASY RESCUE Manual Del Usuario

PERIODIC CHECKING OF
PERSONAL PROTECTIVE EQUIPMENT
EASY RESCUE
DEVICE IDENTIFICATION SHEET
Trademark
Reference standards EN 795, EN 1909, EN 12278
PARTS IDENTIFICATION
PRIMARY ELEMENTS Flanges, pulleys, connectors, bolts and nuts.
SECONDARY ELEMENTS /
REPLACEABLE PARTS /
Fill-out this inspection sheet following the inspection procedure, photographs and instructions supplied by the manufacturer, which you can
download from www.climbingtechnology.com. Attention! The examiner's verdict on the severity of the anomaly must be based on objective
criteria and the specific training received. The producer accepts no responsibility deriving from inexact information recorded by the user or
servicer.
DEVICE PERIODIC CHECK SHEET
1) HISTORY AND GENERAL CHECK
1.1 Check the existence and the readability of the marking details, in particular the CE symbol and the applicable EN norm/standard.
1.2 Check that device has not exceeded the storage and/or in-use lifetime, as stated in the specific instructions for use.
1.3 Check that the device is intact and no parts are missing (check against a new product).
1.4 Check that the device has not been modified outside the factory or serviced in a non-approved centre (check against a new
product).
1.5 Check that the device has not experienced an exceptional event (e.g. fall from height, violent blow, etc.). Even in the absence of
visible defects or deterioration, the original strength could be seriously reduced.
2) VISUAL CHECK
2.1 CHECKING THE FLANGES
Make sure there are no cuts, cracks or sharp edges. Make sure there are no incisions deeper than 1 mm. Make sure that areas of
wear are no deeper than 1 mm, paying particular attention to where the cable or connectors are in contact with the device. Make
sure there is no corrosion or oxidation.
2.2 CHECKING THE PULLEYS
Make sure there are no deformations, cuts or cracks. Make sure that areas of wear are no deeper than 1 mm paying particular
attention to where the rope or cable runs in the pulley.
Aludesign S.p.A. Via Torchio 22, 24034
Manufacturer
Cisano B.sco (BG) ITALY
PRO23-2P656CTEN_rev.7 09-19