Yakima HoldUp Manual Del Usario

Install thIs
product on 2"
or 1¼" hItch
receIvers onlY.
• Do not use with a hitch-
extender.
• Do not use with a 1-1/4"
hitch adapter.
• Do not install on trailers,
campers, or RVs.
• Do not install if spare tire
causes interference with
bikes, or folded carrier.
• Not for use on bikes with
front fenders.
In addition, some undersized
receivers may not accept this
product. If you do not know the
capabilities of your hitch receiver,
consult an automotive professional.
boLT (4x)
LoCK wAShER (4x)
wAShER (4x)
wRENCh (1x)
LoCK wAShER (1x)
Important warnIng
I
t Is crItIcal that all yakIma racks and accessorIes be properly and securely attached to your vehIcle
result In an automobIle accIdent
securIng the racks and accessorIes to your car
, ,
for adjustment wear and damage
your yakIma product prIor to InstallatIon or use
mechanIcal experIence and are not thoroughly famIlIar wIth the InstallatIon procedures
professIonal Installer such as a qualIfIed garage or auto body shop
1033533E-1/15
Registration
whEEL TRAY
ASSEmbLY (1x)
SAFETY CLIP (1x)
hITCh boLT (1x)
,
and could cause serIous bodIly Injury or death to you or to others
,
checkIng the attachments prIor to use
. t ,
herefore you must read and understand all of the InstructIons and cautIons supplIed wIth
. I
f you do not understand all of the InstructIons and cautIons
For Your
Safety
warranty
on-line
YAKImA.com
FRoNT
REAR whEEL TRAY
ASSEmbLY (1x)
.
TooLS REQUIRED:
AdJuSTABlE WrEncH
KEY (2x)
LoCKING CAbLE (1x)
2" bASE (1x)
(2" Holdup only)
1 1/4" bASE (1x)
(1 1/4" HolduP only)
. I
mproper attachment could
. y
ou are responsIble for
,
and perIodIcally InspectIng the products
,
or If you have no
,
you should have the product Installed by a
Part #1033533 Rev.E