Bosch NGT73 Instructivo De Instalación
Bosch NGT73 Instructivo De Instalación

Bosch NGT73 Instructivo De Instalación

Ocultar thumbs Ver también para NGT73:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

PLEASE READ INSTRUCTION BEFORE PROCEEDING
IMPORTANT: Save these instructions for the local electrical inspector's use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
Important Safety Instructions
Installation must conform with local codes or, in
the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1.
The appliance must be electrically grounded in ac-
cordance with local codes or, in the absence of
local codes, with the National Electrical Code ANSI/
NFPA 70, latest edition. (In Canada, installation must
be in accordance with the CAN 1-B149.1 and .2
Installation Codes for Gas Burning Appliances and/
or local codes )
This appliance has been tested in accordance with
ANS Z21.1, Standard for Household Cooking Ap-
pliances (USA) and in accordance with CANl.l-M81
Interim Reqt #58 Domestic Gas Cooktops
(CANADA).
WARNING: Improper installation, ad-
!
justment, alteration, service or mainte-
nance can cause injury or property damage. Re-
fer to this manual. For assistance or additional
information consult a qualified installer, service
agency, manufacturer or the gas supplier.
The cooktop must be used in conjunction with a
suitable ventilation system.
Power Requirements and Grounding
Power Supply: 120 Volts, 15 Ampere, 60 Hz. This appliance is
factory equipped with a 5-foot power supply cord with a 3-
prong grounding plug (with polarized parallel blades).
INSTALLATION INSTRUCTIONS MANUAL
STEEL GAS COOKTOPS with FULL-SURFACE GRATES
30" MODELS: NGT73, NGP73
36" MODELS: NGT93, NGP93
OWNER: Please retain these instructions for future reference.
Do Not Discard This Sheet
TO PREVENT ELECTRICAL SHOCK, THE THIRD
GROUND PRONG SHOULD NOT UNDER ANY
CIRCUMSTANCES, BE CUT OR REMOVED. IT
MUST BE PLUGGED INTO A MATCHING GROUND-
ING TYPE RECEPTACLE AND CONNECTED TO A COR-
RECTLY POLARIZED 120-VOLT CIRCUIT.
circuit is recommended which is in compliance
with the NEC.
If there is any doubt as to whether the wall receptacle
is property grounded, the customer should have it
checked by a qualified electrician.
CAUTION: Before you plug in an electrical cord,
be sure all controls are in the OFF position.
Gas Requirements
Supply Pressure
Natural Gas - 6 inches water column
(14.9 Millibars) minimum.
Propane Gas - 11 inches water column
(27.4 Millibars) minimum.
The maximum gas pressure to this appliance is not to
exceed 14.0 inches water column (34.9 Millibars).
PROPANE GAS INSTALLATION
The propane gas tank must be equipped with its own
high pressure regulator in addition to the pressure regu-
lator supplied with this unit.
The cooktop is shipped from the factory for use with
natural gas. For use with LP, a conversion kit is re-
quired and must be purchased separately. Contact BSH
or your retailer to obtain kit # NEZ1065. A qualified
technician or installer must do the conversion.
Leak testing of the appliance shall be conducted
according to manufacturer's instructions.
A separate
Tabla de contenido
loading

Resumen de contenidos para Bosch NGT73

  • Página 9: Favor De Leer Las Instrucciones Antes De Seguir

    INSTRUCTIVO DE INSTALACIÓN ESTUFAS DE GAS DE ACERO con PARRILLAS SUPERFICIALES COMPLETAS MODELOS DE 30": NGT73, NGP73 MODELOS DE 36": NGT93, NGP93 FAVOR DE LEER LAS INSTRUCCIONES ANTES DE SEGUIR IMPORTANTE: Guarde estas instrucciones para el uso del inspector eléctricista local.
  • Página 10: Gabinetes Y Recortes De La Superficie De Trabajo

    GABINETES Y RECORTES DE LA SUPERFICIE DE TRABAJO Los requerimientos de dimensiones Figura 1 – Dimensiones Instaladas (de los bordes de la estufa) en las Figuras 1 y 2 son para superficies combustibles. Cuando la superficie está protegida por un material listado por UL como un Protector de Piso y de Pared y esta cubierto con no menos de hojalata...
  • Página 11: Fijar Las Abrazaderas A La Estufa

    INSTALAR LA ESTUFA 1. Sellar la estufa Figura 3 Aplique la cinta de espuma que viene con la estufa al lado inferior Recorte de la superficie – superfi- de la estufa a lo largo del perímetro antes de instalarla. Vea Fig. 4. cies de trabajo sólidas Importante: Para instalaciones de materiales en superficies sólidas ®...
  • Página 12: Conectar La Alimentación Eléctrica

    Canadá. BSH Home Appliances Corp. no es responsable de productos que son transportados desde los EE.UU. a Canadá. Consulte a su distribuidor canadiense local. Nota: La estufa de Bosch al cual se refiere este manual es hecho por BSH Home Appliances Corp. 5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/944-2904 ©...

Este manual también es adecuado para:

Ngp73Ngt93Ngp93

Tabla de contenido