Craftsman 19A70041791 Manual De Instalación

MULCH KIT STAMPED 42" DECK
Model No. 19A70041791
Model 19A70041791 mulch kit is designed for use with select 42-inch two-blade
cutting decks. Refer to your tractor's Operator's Manual to assure compatibility.
Carton Contents
Before beginning installation, remove all parts from the carton to make sure
everything is present. Carton contents are listed below and shown in Figure 1. Part
numbers are listed in parentheses.
• Two Mulching Blades (742-0616A)
• One Deck Mulch Plug Assembly (631-05195A)
• One Wing Knob (720-04122)
• One Flat Washer (736-0159)
• One Mulch Plug Wire (747-06686)
Figure 1
Blade Installation
Before beginning installation, place the tractor on a firm and level surface, set the
parking brake, place the PTO in the disengaged (OFF) position, stop the tractor's
motor and remove the ignition key to prevent unintended starting.
Cutting blades are sharp. Always protect hands by wearing heavy leather work
gloves to grasp blades.
1. Remove the cutting deck from beneath the tractor as instructed in your
tractor's Operator's Manual.
2. Gently flip the deck over to expose its underside.
3. Stabilize one of the cutting blades with a blade lock tool or a block of wood.
See Figure 2.
INSTALLATION MANUAL
WARNING
WARNING
Figure 2
Form No. 769-19050
(November 12, 2018)