Battery Warning; Technical Specifications - Cochlear Phone Clip Manual Del Usuario

•
Opening the Cochlear Phone Clip might damage it. If problems occur that
cannot be resolved, consult your hearing care professional.
•
The Cochlear Phone Clip may only be repaired by an authorized service
centre.
•
Do not use the Cochlear Phone Clip in areas where RF transmission is
prohibited, e.g., in planes, etc.
•
Only connect the Cochlear Phone Clip to connections for which it is
explicitly intended.
Built-in battery care
Please observe the following:
•
Your product is powered by a rechargeable battery. A new battery performs
optimally after two or three complete charge and discharge cycles.
•
The battery can be charged and discharged hundreds of times, but will
eventually wear out.
•
Unplug the charger from the mains socket and the product when not in use.
•
If left unused, a fully charged battery will lose its charge over time.
•
Leaving the product in hot places will reduce the battery's capacity and
service life.
•
A product with a cold battery may not work temporarily, even if fully
charged. Battery performance is particularly limited in temperatures well
below freezing.

Battery warning

Caution: The battery used in this product may present a risk of fire
or chemical burn if misused.
•
The battery in your product cannot be removed or replaced by the user.
Do not attempt to open the product. Any attempt to do so may result in
damage. Using other batteries may present a risk of fire or explosion and
void the warranty.
•
Only recharge the Cochlear Phone Clip with the recharger that was
supplied with the product.
•
Dispose of batteries according to local regulations. Please recycle when
possible.
•
Do not dispose of the battery as household waste or in a fire as it may
explode.
Charger care
•
Please observe the following if the product is supplied with a charger.
•
Do not attempt to charge your product with anything other than the AC
adapter provided. The use of other chargers may damage or destroy the
product and could be dangerous. Use of other chargers may invalidate any
approval or void the warranty.
•
For availability of approved accessories, please check with your hearing
care professional.
•
Charge the product according to the instructions provided.
Charger warning
•
When you disconnect the power cord or any accessory, grasp and pull the
plug, not the cord.
•
Never use a charger that is damaged.
•
Do not attempt to disassemble the charger because it may expose you to a
dangerous electric shock.
•
Incorrect reassembly can cause electric shock or fire when the product is
subsequently used.
•
Avoid charging your product in extremely high or low temperatures and do
not use the charger outdoors or in damp areas.
•
Do not charge the Cochlear Phone Clip while it is being worn.
Made for iPhone
Made for iPhone means that an electronic accessory has been designed to
connect specifically to iPhone and has been certified by the developer to meet
Apple performance standards. Apple is not responsible for the operation of
this device or its compliance with safety and regulatory standards. Please note
that the use of this accessory with iPhone may affect wireless performance.

Technical specifications

Operating range
Power supply
Wireless
Operating temperature
Storage temperature
Temperature test, transport and storage information
The product is subject to various tests in temperature and damp heating
cycling between -25° C and +70° C according to internal and industry
standards.
Wireless Accessory type designations for models
included in this User Manual are:
FCC ID QZ3BTB-2, IC 8039C-BTB2, IC model: BTB-2
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications can void the user's authority to operate the
equipment.
List of countries:
The products are in compliance with the following regulatory
requirements:
• In EU: the device conforms to the Essential Requirements according
to Annex I of Council Directive 93/42/EEC for medical devices (MDD)
and essential requirements and other relevant provisions of Directive
1999/5/EC (R&TTE). The declaration of conformity may be consulted at
www.cochlear.com
• Products with wireless functionality are intended for sale in countries
within the European Economic Area as well as Switzerland. Specification
of restrictions: You are not allowed to operate the equipment within 20
km of the center of Ny Ålesund, Norway.
• In US: FCC CFR 47 Part 15, subpart C, section 15.249.
• Other identified applicable international regulatory requirements
in countries outside the EU and US. Please refer to local country
requirements for these areas.
• Products are in compliance with EN 300 328.
• In Canada the Phone Clip is certified under the following certification
number: IC:8039C-BTB2.
Up to 7 meters or more
Mains socket
2,4 GHz
0 to 45° C
-20 to 45° C