D-Link DFM-560EL Guía De Instalación Rápida

Quick Guide for Installing D-Link DFM-560EL
External Modem Drivers
The CD includes below:
1. \ Manual \: Modem manual.
2. \: Modem drivers for Windows 98/ME/NT4.0/2000/XP
3. Run SV\Picshell to install SuperVoice or other software.
Note: The detailed manual has been put into PDF file in the CD,
please run Acrobat Reader 4.0 to read it.
Quick software installation
Windows 95 B (OSR2)
Please insert the driver CD supplied when you see the message of
1.
D-Link DFM-560EL External Modem, then click Next to search for
the driver.
2. Click Other Locations... to install from the installation disk.
3. Select the location of G: and click OK to continue. (G is the letter of
CD-ROM drive).
Click Finish to end this installation procedure.
4.
When you see the message of Wave Device for Voice Modem, then
5.
click Next to search the driver.
Click Other Locations... to install from the installation disk.
6.
Select the location of G: and click OK to continue. (G is the letter of
7.
CD-ROM drive).
Click Finish to end this installation procedure.
8.
Windows 98
1. Please insert the driver CD supplied when you see the message of
D-Link DFM-560EL External Modem, then click Next to search for
the driver.
2. Select the Search for the best driver for your device. [Recommended]
and click Next to continue.
3. Select the CD-ROM drive and click Next to start the search.
4. Click Next to start the installation.
5. Click Finish to end this installation procedure.
6. When you see the message of Wave Device for Voice Modem, then
click Next to search the driver.
7. Select the Search for the best driver for your device. [Recommended]
Quick software installation
and click Next to continue.
8. Select the CD-ROM drive and click Next to start the search.
9. Click Next to start the installation.
10. Click Finish to end this procedure.
Windows ME
1. Please insert the driver CD supplied when you see the message of
D-Link DFM-560EL External Modem appearing., select Specify the
location of the driver [Advanced] then click Next to search for the
driver.
2. Select the Search for the best driver for your device. [Recommended],
Specify a location and type in H:\ (H is the letter of the CD-ROM drive),
then click Next to continue.
3. Click Next to start the installation.
4. Click Finish to end this installation procedure.
5. When you see the message of Wave Device for Voice Modem, select
Specify the location of the driver [Advanced] then click Next to install
the wave device.
6. Select the Search for the best driver for your device. [Recommended],
Specify a location and type in H:\ (H is the letter of the CD-ROM drive),
then click Next to continue.
7. Click Next to start the installation.
8. Click Finish to end this procedure.
Windows NT4.0
1. Please go to Start>My Computer\ Control Panel, then double-click on
Modems icon to install a new modem.
2. Select Don't detect my modem; I will select it from a list, then click
Next to continue.
3. Click Have Disk.. to install from the installation disk.
4. Select the location of H: and click OK to continue. (H is the letter of
CD-ROM driver).
5. Select D-Link DFM-560EL External Modem form the list of Models,
then click Next to continue.
6. Select Selected ports and then select COM port that selected before,
Click Next to start installing the selected modem.
7. Click Finish to complete the installation.
8. Click Close to end this procedure as you see the D-Link DFM- 560EL
External Modem NOTE: If Remote Access Service (RAS) is installed
on your computer, Windows NT will ask you to reconfigure Dial-Up
Networking for the new Modem.
9. Move your cursor as following sequence Start\Settings\Control Panel
Quick software installation