Hubbell H-MOSS NEMA 4X Instrucciones De Instalación

Occupancy Sensor – Installation Instructions
DESCRIPTION
Hubbell Adaptive Technology wall mount occupancy sensors are designed to reduce installation time and prevent callbacks resulting from
improper sensor adjustment. Hubbell sensors study their environment and automatically adjust the time delay and sensitivity to optimize the
sensor's performance for the specific application. Hubbell AT sensors must be used in conjunction with Hubbell CU series control units. The
control units provide a 24VDC power supply for 1 to 4 sensors. The correct control unit must be selected for the operating voltage of the
application. Hubbell offers the following control units:
- CU300A (Auto On), CU300HD:120/277VAC, 60 Hz.
- CU300M ( Manual On): 120/277VAC, 60 Hz.
- CU347: 347VAC, 60 Hz.
Each sensor requires a Mounting Kit.
PRE-INSTALLATION
1. NOTICE: For installation by a qualified electrician in accordance with national and
local codes and the following instructions.
2. CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing.
Never wire energized electrical components.
3. CAUTION: USE COPPER CONDUCTORS ONLY.
4. Check to see that the device's rating is suitable for the application.
5. NOTICE: Do not install if any damage to product is noted.
COVERAGE AND PLACEMENT FIG. 1&2
The pattern of the AHP1600WRP sensor is shown in fig. 1 at right.
• Sensor must be used with appropriate enclosures and/or fittings to maintain NEMA 4X rating.
• Sensor must be mounted with the access port at the bottom.
• Sensors can be wall or ceiling mounted.
• Sensors must be mounted at least 4' from HVAC vents to avoid air current interference.
• Sensors should NOT be installed near a steam source.
• Do NOT install in view of strong direct or reflected light sources.
Wiring Device – Kellems
Hubbell Incorporated (Delaware)
40 Waterview Dr.
Shelton, CT 06484
(475)-882-4800
PD2551-01 10/13
H-MOSS NEMA 4X|IP66 Wall Mounted
FIG. 3
FIG. 4
ENGLISH
FIG. 1
FIG. 2
®