User Instructions - Lightway SP-2016PIRB Manual Del Usuario

User instructions

Before using the Outdoor Security Light, please read all these instructions
carefully and save them for future reference. Basic safety precautions should
always be followed. PLEASE READ AND SAVE ALL INSTRUCTIONS BEFORE
INSTALLING AND USING THE OUTDOOR SECURITY LIGHT.
NOTE: Installation must be performed by a qualified electrician or a person who
is informed about the standards and technical requirements of the appliance
and its proper installation.
WARNING: Before commencing installation or maintenance, the electricity
supply MUST be turned off at the circuit breaker box or fuse. DO NOT rely on
wall switch alone to turn off power.
How to Use
Warning: After installation of the security light, no further rotation positioning
should be done. See diagram below to help with operation of the security light.
1. Setting the sensor for testing:
 Using the "ON-TIME" switch, move to the "TEST" position. When in the
"TEST" position, the security light will operate during the day or night. The
lights will stay on for 5 seconds after all motion has stopped.
 Turn the "RANGE" dial to the "MIN" position.
 Aim the motion sensor in the general direction of the area to be covered.
NOTE: The motion sensor will need to be completely warmed up (about 30
seconds) before beginning the set-up process.
User Instructions
9