Safety Instructions - Lightway SP-2016PIRB Manual Del Usuario

Safety instructions

CAUTION:
WARNING:
listed below may result in electric shock, fire or serious personal injury. The
warnings, cautions, and instruction discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are a factor which cannot be
built into this product, but must be supplied by the operator.
Although the Outdoor Security Light is easy to operate, for your safety, the
warnings below must be followed:
1. Do not place the security light near a heat source.
2. Risk of fire. Do not aim the lamps at a combustible surface within 3ft.
3. Do not rely on wall switch alone to turn off power. Turn off power at the
circuit breaker or fuse.
4. Some codes require installation by a qualified electrician.
5. This product is intended for use with the enclosed gasket and with a junction
box marked for use with wet locations.
6. To avoid water damage and electrical shock, keep lamp holders 30 below
horizontal. Keep lamps at least 1 in. from the sensor. Do not allow the lamps
to block the sensor.
7. The security light must not be installed if:
A. There are missing parts.
B. If it appears to be faulty.
Electric power
If electric circuit is overloaded with other appliances, your Outdoor Security Light
may not operate properly. The Outdoor Security Light should be operated on a
separate electrical circuit from other operating appliances.
8
Read and understand all instructions. Failure to follow all instructions
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.
SAVE THESE INSTRUCTIONS!
Safety Instructions