Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation
Instructions
Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: GEAppliances.com
❒ BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
Save these instructions
for local inspector's use.
IMPORTANT
Observe all governing codes and
ordinances.
Note to Installer – Be sure to leave these instructions with
the Consumer.
Note to Consumer – Keep these instructions for future
reference.
Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
Completion time – 1 to 3 hours
the oven.
recommend that two people install this microwave oven.
of this kit.
WARNING
FOR YOUR SAFETY:
WARNING
switch power off at service panel and lock the service
disconnecting means to prevent power from being switched
Microwave Oven
Built-In Trim Kits
JX827 and JX830
PARTS INCLUDED
PART
NOTE:
from spending extra time locating a replacement in case
1
QUANTITY
Screw A
3 extra
❒ 4 mm x 16 mm
4 required
Tabla de contenido
loading

Resumen de contenidos para GE JX827

  • Página 5: Kits De Horno Microondas Con Terminaciones Incorporadas

    Instrucciones Kits de Horno Microondas con Terminaciones Incorporadas de Instalación JX827 and JX830 ¿Preguntas? Llame a 800.GE.CARES (800.432.2737) o Visite nuestro sitio web en: GEAppliances.com PIEZAS INCLUIDAS ❒ ANTES DE COMENZAR Lea estas instrucciones en su totalidad y atentamente. PIEZA...
  • Página 6: Herramientas Que Necesitará

    Instrucciones de Instalación HERRAMIENTAS QUE NECESITARÁ ❒ 1 UBIQUE E INSTALE UNA OLLA DE LA BASE ❒ frontal del horno microondas y centre la misma sobre ❒ ❒ Lápiz que la pestaña frontal quede contra la pared frontal ❒ ❒ Cuchillo ❒...
  • Página 7: Instalación De Los Rieles

    Instrucciones de Instalación ❒ 2 INSTALACIÓN DE LOS RIELES ❒ 4 CONTROL DE LA NIVELACIÓN Controle la nivelación colocando un nivel en el frente y todo lo que haya dentro del horno microondas, incluyendo necesario agregar cuñas de madera debajo de la olla de la base para nivelar el frente del microondas con la parte trasera o un costado con el otro.
  • Página 8: Instalación De La Estructura Del Kit Con Terminaciones

    Instrucciones de Instalación ❒ 6 INSTALACIÓN DE LA ESTRUCTURA ❒ 7 REEMPLACE CUALQUIER ÍTEM FLOJO DEL KIT CON TERMINACIONES y su soporte correspondiente, que fueron retirados del Terminaciones alrededor del horno. interior del horno microondas. Asegure el Kit con Terminaciones colocando cuatro Guarde estas instrucciones de instalación y tornillos gabinete.

Este manual también es adecuado para:

Jx830

Tabla de contenido